We are making 10 watt flood light with sic IC and we are facing issue with 4kv and 440volt because if we use mov 561 then surge pass 4kv and high voltage pass only 400volt and if we use mov 621 then surge fail at 3.5kv and high voltage pass 440volt , please suggest the mov which one can use those we can achieve 4kv and 440volt pass both parameter .
Jagmohan rawat
Asked: May 27, 20222022-05-27T11:18:50+05:30 2022-05-27T11:18:50+05:30In: Power Management
LED flood light
Share
Related Questions
- How do microcontrollers optimize power consumption to extend battery life in battery-powered devices?
- Why Just 250 MHz Variants in STM32H5?
- How to Increase TLE9180D31QKXUMA1 Maximum PWM Frequency?
- What is the EVADC Difference Mode after Limit Checking?
- How do you choose the IGBT category according to current and voltage?
Hello Mr. Jagmohan, Please share a Schematic of your input protection circuit, & please let us know what failure is getting or components are damaged after the surge (e.g Fuse burned, MOV burned, Mosfet short, or track burned). If Mosfet is getting damaged - then we need to work on a selection oRead more
Hello Mr. Jagmohan,
Please share a Schematic of your input protection circuit, & please let us know what failure is getting or components are damaged after the surge (e.g Fuse burned, MOV burned, Mosfet short, or track burned).
Hi , There is only issue with MOV tolerance if you use less tolerance mov or High Surge MOV your issue will be solve Thanks sandeep
Hi ,
There is only issue with MOV tolerance if you use less tolerance mov or High Surge MOV your issue will be solve
Thanks
sandeep
See less