Hello,
I have a custom board with a STWLC38JRM.
Everything was fine and I was able to flash it with STSW-WPSTUDIO v1.8.4 through the dev board STEVAL-WLC38RX and FT_SDA/FT_SCL/VBUS/AGND pins.
I attempt to make a few test and I disabled internal over temperature security in config. After that, I’m not able to connect to the STWLC38JRM once more. I attempted the chip with “RX” and “Empty” in WPSTUDIO without any victory. I as of now had a similar issue and the chip was in Empty state.
Is it possible to “factory reset” the chip without I2C link ?
Thank you.
Hi.We as it were utilize I2C to upgrade fw, it would be ideal if you make sure FT260 dongle is ok , about GUI connect issues, i propose you use a1_wlc38_downfw.bat to download fw automatic. Also it would be ideal if you check GUI log and post it if still fail. Thank You
Hi.
We as it were utilize I2C to upgrade fw, it would be ideal if you make sure FT260 dongle is ok ,
about GUI connect issues, i propose you use
a1_wlc38_downfw.bat to download fw automatic.
Also it would be ideal if you check GUI log and post it if still fail.
See lessThank You