Hi there! I’m designing a PCB at the moment using the ESP32- C3-MINI-1. One thing I’m wondering is, how to design the board in such a way, that I’m suitable to upload my application without pressing the boot and enable buttons ...Read more
Hello, The CY8CKIT-002 software engineer, too called miniProg3, can support CCG5 burning. With respect to the CYD5235 firmware code, what are your requirements and terminal products? Thanks
Hello,
The CY8CKIT-002 software engineer, too called miniProg3, can support CCG5 burning. With respect to the CYD5235 firmware code, what are your requirements and terminal products?
Thanks
See less
Still, you would use exactly the same circuit but with IO0 replaced with IO0, If you were to use something like a CP2102 or other USB-serial chip. Still, you generally do not need the auto-reset circuit as that functionality is built-in If you are intending to use GPIO18/ 19 to program the ESP32C3 dRead more
Still, you would use exactly the same circuit but with IO0 replaced with IO0, If you were to use something like a CP2102 or other USB-serial chip.
Still, you generally do not need the auto-reset circuit as that functionality is built-in If you are intending to use GPIO18/ 19 to program the ESP32C3 directly. (But do note that you may want to have * some * way to manually put the C3 into download mode while developing if you do something that stops the internal USB-serial- JTAG from working, like accidentally configuring the USB pins as GPIOs).
See less