In Renesas RH850 CS+ IDE , program runs when we put break point and programs do not run when break point is removed.
I have attached workspace for UART done on RA2L1 and FSP v3.5.0 to set BR- 1000000. Please make sure your USB to TTL convertor supported with 1MBps speed. You need to see Baud rate modulation is enabled and set the BR to 1000000, refer below snap Please go through the HW manual of RA2L1 to check theRead more
I have attached workspace for UART done on RA2L1 and FSP v3.5.0 to set BR- 1000000. Please make sure your USB to TTL convertor supported with 1MBps speed.
You need to see Baud rate modulation is enabled and set the BR to 1000000, refer below snap
Please go through the HW manual of RA2L1 to check the UART error rate calculation.
See less
In CS+ CC IDE for RH850,when debug tool is connected click on Debug tool settings then click on Flash Options Settings ,OPBT0 as DA20FDCF and OPBT1 as FFFFFDFF for LPD-1 and OPBT0 as BA20FDCF and OPBT1 as FFFFFDFF for LPD-4 and issue is solved program executes continuously .
In CS+ CC IDE for RH850,when debug tool is connected click on Debug tool settings then click on Flash Options Settings ,OPBT0 as DA20FDCF and OPBT1 as FFFFFDFF for LPD-1 and OPBT0 as BA20FDCF and OPBT1 as FFFFFDFF for LPD-4 and issue is solved program executes continuously .
See less