Home/Transmitting

volt.tech Latest Questions

Michael Findley
  • 0
Michael Findley
Asked: February 27, 2024In:
  • 0

Hello,I’d like to utilize GPIO00 … GPIO04 as outputs to choose the utilized coil from a coil array for power transmitting.I’ve seen the i2c addresses of the GPIO’s setup at 0x30 and taken after. I’m wondering what address is foreseen ...Read more

Hello,

I’d like to utilize GPIO00 … GPIO04 as outputs to choose the utilized coil from a coil array for power transmitting.

I’ve seen the i2c addresses of the GPIO’s setup at 0x30 and taken after. I’m wondering what address is foreseen to studied or type in the GPIO information. Have I overseen anything?

Thanks in case anybody has an idea!

Read less
gpioGPIO04i2cpowerSTWBC86Transmitting
  1. Alex thomas

    Hello Michael, We as it were support huge volume for firmware customize, and it can spare outside MCU to control STWBC86. for 5-coil array you fair have to be each gpio high or low, it can use I2CREG_GPIOx_FUNC to control. Also you utilize equipment register to control GPIO, but it'll make a few misRead more

    Hello Michael,

    We as it were support huge volume for firmware customize, and it can spare outside MCU to control STWBC86.

    for 5-coil array you fair have to be each gpio high or low, it can use I2CREG_GPIOx_FUNC to control.

    Also you utilize equipment register to control GPIO, but it’ll make a few mistake and influence to other gpio.

    So i prescribe to use I2CREG_GPIOx_FUNC to control.
    Thank You
    Alex

    See less
    • 0