Hello, I’ve lipo battery connected to tp4056 (with protection), and it’s connected to a 5v output boost module. How can I connect it to the board? And also can I have a USB connection to the board without burning the ...Read more
Hello, I’ve lipo battery connected to tp4056 (with protection), and it’s connected to a 5v output boost module. How can I connect it to the board? And also can I have a USB connection to the board without burning the module?
Read less
Hii, From boost converter (u really do not need it but anyway.) to ESP32- wroom 5v pin (from photo bottom left pin) and from charge- to GND (ANY OF THEM). Can connect a USB to the ESP32 WROOM directly (with this connection in place, no need to disconnect) and flash any firmware you want, also disconRead more
Hii, From boost converter (u really do not need it but anyway.) to ESP32- wroom 5v pin (from photo bottom left pin) and from charge- to GND (ANY OF THEM).
Can connect a USB to the ESP32 WROOM directly (with this connection in place, no need to disconnect) and flash any firmware you want, also disconnect the USB, and if the battery is full and it’ll work.
Can also connect a USB to the TP4056 for charging WHILE it feeds the ESP32.
You really do not need the Boost since the TP4056 will output3.7 v and you have a 1000mah (milli amps hour) battery which will allow the ESP32 to work for a good while (depending on what u are doing etc) before recharging. In this configuration just connect the OUT to3.3 v (top left) and OUT- to any GND pin.
But u will need a USB connection to load any firmware and later disconnect it and let the battery feed the ESP32.
Enjoy.
See less