Hello All,Need a few offer assistance here.I need to design CAN based WAKE UP. In any case is there any provision in TLE9893 where I can filter/choose CAN Messages for specific WAKE UP.In User Manual, there are two blocks specified ...Read more
Hello All,
Need a few offer assistance here.
I need to design CAN based WAKE UP. In any case is there any provision in TLE9893 where I can filter/choose CAN Messages for specific WAKE UP.
In User Manual, there are two blocks specified as ‘Wake receiver’ and ‘WUP detection‘ to create WAKECAN. If there are details over these two blocks, it would be helpful.
Thanks and Best regards,
Neha
Read less
Hello @Neha, The wake-up occasion over CAN (CAN transport activity) is an interconnect from the CANTRX (WAKECAN).The wake-up over CAN can be empowered via WAKE_CTRL.CAN_WAKE_EN. After a wake-up, the status is visible in WAKE_STS.CAN. The status can be cleared via WAKE_STS_CLR.CAN_CLR. The further seRead more
Hello Rutuja,
See lessThe wake-up occasion over CAN (CAN transport activity) is an interconnect from the CANTRX (WAKECAN).
The wake-up over CAN can be empowered via WAKE_CTRL.CAN_WAKE_EN. After a wake-up, the status is visible in WAKE_STS.CAN. The status can be cleared via WAKE_STS_CLR.CAN_CLR.
The further setup related details are talked about in segment 12.7.4 CAN sleep mode (wake capable) of the TLE989x UM.
It talks about approximately the configuration and wake-up design detection.
Thank you
Best Regards
Sachin