Home/renesas flash programmer

volt.tech Latest Questions

Raja Singh
  • 0
Raja Singh
Asked: May 30, 2022In:
  • 0

How to use MD pin in Flash time or Debug time or how to program Renesas RA2L1 MCU by using   Renesas flash programmer ?

How to use MD pin in Flash time or Debug time or how to program Renesas RA2L1 MCU by using   Renesas flash programmer ?

Read less
debug timeflash timeMD pinra2l1renesasrenesas flash programmerRenesas Microcontrollerrenesas ra2l1
  1. Support

    Hi mr. Raja You have to make MD pin active low while SCI boot (flashing with UART ) & if you want to debug the make it high with 10 K pullup & isolate pull down resistor

    Hi mr. Raja

    You have to make MD pin active low while SCI boot (flashing with UART )

    & if you want to debug the make it high with 10 K pullup & isolate pull down resistor

    See less
    • 0
Rutuja
  • 1
Rutuja
Asked: March 23, 2022In:
  • 1

We are using Renesas Controller RL78 F1x, for this we required CS+ IDE. Basically I want to know CS+IDE and Renesas Flash Programmer is free or not ?

We are using Renesas Controller RL78 F1x, for this we required CS+ IDE. Basically I want to know CS+IDE and Renesas Flash Programmer is free or not ?

Read less
renesas compiler ccrhrenesas compiler ccrlrenesas flash programmerrenesas ide cs+
  1. Sandeep Kondhalkar

    Hello Rutuja, Renesas flash programmer is totally free. And CS+ IDE evaluation version is free for 60 days.  If code size exceeded 64 Kb(for RL78) and 256KB (for RH850)then you have to purchase complier license.

    Hello Rutuja,

    Renesas flash programmer is totally free.
    And CS+ IDE evaluation version is free for 60 days.  If code size exceeded 64 Kb(for RL78) and 256KB (for RH850)then you have to purchase complier license.

    See less
    • 0