Hello All, I’ve designed a very smooth and low ripple 5V force for my board. This gets coupled through an LDO 3.3 V controller to feed the ESP32 (same as most boards out there). When the ESP32 transmits WiFi, I see ...Read more
Hello All,
I’ve designed a very smooth and low ripple 5V force for my board. This gets coupled through an LDO 3.3 V controller to feed the ESP32 (same as most boards out there). When the ESP32 transmits WiFi, I see a 50- 100mV drop in the 3.3 V rail and it’s being coupled through to the 5V side of the 3.3 V reg.
Large electrolytic caps on the 5V side and the 3.3 V side bettered it greatly (to the 50- 100mV measured result) but I would like to see further improvements.
Most 3.3 V LDO regs all appear to have the same/similar load regulation characteristics so I’m not yet convinced a change in reg will resolve the issue. Having a 16-bit ADC on board means I’m very sensitive to voltage changes on the 5V rail.
Has anyone overcome this issue already?
Thanks
Read less
It will not. Note that the 3.3 V LDO doesn't" regulate" its input voltage. The drop you see on the 5V side is the result of the ESP drawing more current during TX and the 5V supply/ rail failing to a) give that amount of current while maintaining 5V, or b) react to the change in current quickly enouRead more
It will not. Note that the 3.3 V LDO doesn’t” regulate” its input voltage. The drop you see on the 5V side is the result of the ESP drawing more current during TX and the 5V supply/ rail failing to a) give that amount of current while maintaining 5V, or b) react to the change in current quickly enough. There is nothing the LDO can do to change the current the load draws from the force.
So some options are
See lessa) beef up the power supply
b) (further) reduce the impedance of the power supply (i.e. further caps), and make sure supply and ground/ return lines and connections have low resistance
c) consider decoupling only the sensitive circuitry (ADC,.) from the 5V supply, which may be easier to achieve (less current) than stabilizing the whole 5V rail.