Home/input pin

volt.tech Latest Questions

vsharma
  • 0
vsharma
Asked: July 30, 2022In:
  • 0

I went through the example and verify the signal and varying different frequencies and it works perfectly fine for my eval TC37x board I then tried to change the input pin to #define PWM_IN IfxGtm_TIM1_1_P02_1_IN with the expectation if I changed the ...Read more

I went through the example and verify the signal and varying different frequencies and it works perfectly fine for my eval TC37x board

I then tried to change the input pin to #define PWM_IN IfxGtm_TIM1_1_P02_1_IN with the expectation if I changed the CMU_CLKEN_CLK1, I will get the same result

IfxGtm_Cmu_enableClocks(&MODULE_GTM, IFXGTM_CMU_CLKEN_CLK1); /* Enable the CMU clock 1 */

But my g_measuredPwmFreq_Hz = +Inf

and g_measuredPwmDutyCycle = NaN

The data sheet calls out the CMU_CLK0, CMU_CLK1, CMU_CLK6, CMU_CLK7 are used for the TIM filters counters.

What did I do wrong or assume changing the input pin to TIM1 and enable the CLK1 will not work in this case?

Read less
CLK1input pinTC37xboardTIM1
  1. pallavi sharma

    In the example, inside the function IfxGtm_Tim_In_initConfig(), the configuration is for TIM0 CH0 config->timIndex = IfxGtm_Tim_0;config->channelIndex = IfxGtm_Tim_Ch_0; IfxGtm_TIM1_1_P02_1_IN corresponds to TIM1 CH1.

    In the example, inside the function IfxGtm_Tim_In_initConfig(), the configuration is for TIM0 CH0

    config->timIndex = IfxGtm_Tim_0;
    config->channelIndex = IfxGtm_Tim_Ch_0;

    IfxGtm_TIM1_1_P02_1_IN corresponds to TIM1 CH1.

    See less
    • 0