Home/iic

volt.tech Latest Questions

nidhi singh
  • 0
nidhi singh
Asked: October 6, 2022In:
  • 0

Dear Volt.Tech, I’ve been trying to run the IIC master example code with the EK- RA6M3 board but it doesn’t make with the latest FSP version(4.0.0). To workaround this I installed v3.8.0 but I’m facing issues with the IDE where it doesn’t enter the function which has a multi-byte i2c read sequence. I’m using the MAX86161 detector to test this out. Thanks & Regards

Dear Volt.Tech,

I’ve been trying to run the IIC master example code with the EK- RA6M3 board but it doesn’t make with the latest FSP version(4.0.0). To workaround this I installed v3.8.0 but I’m facing issues with the IDE where it doesn’t enter the function which has a multi-byte i2c read sequence. I’m using the MAX86161 detector to test this out.

Thanks & Regards

Read less
fspiicra6m3renesasRenesas Microcontroller
  1. vikas Nagpal

    Hi, Thanks for reaching out to Engineering Community. Could you please check your e² studio version? Please note that FSP versions of 3.7.0 and later require a minimal e² studio version of 2022- 04 and FSP versions of 4.0.0 and later require a minimum e² studio version of 2022- 07. Best regards,

    Hi,

    Thanks for reaching out to Engineering Community.
    Could you please check your e² studio version? Please note that FSP versions of 3.7.0 and later require a minimal e² studio version of 2022- 04 and FSP versions of 4.0.0 and later require a minimum e² studio version of 2022- 07.

    Best regards,

    See less
    • 0