Hi, I need to apply the virtual EEPROMĀ on a RA2E1. In principle, this mechanism works, and I can write and read the record IDs. During the production of the board, I need to program the original content of this rec id. ...Read more
Hi,
I need to apply the virtual EEPROMĀ on a RA2E1. In principle, this mechanism works, and I can write and read the record IDs. During the production of the board, I need to program the original content of this rec id. Is there any documentation or example on how to make the memory address’s binary file starting from 0x40100000?
Thanks, Nidhi
Read less
Hi Nidhi, Thanks for reaching out to Volt.Tech Engineering Community. If I understand right you need to program the data flash of the device just right? The data flash can be written in both ways, by Renesas Flash Programmer, or by self-programming (by the software running on the device). To programRead more
Hi Nidhi,
Thanks for reaching out to Volt.Tech Engineering Community.
If I understand right you need to program the data flash of the device just right?
The data flash can be written in both ways, by Renesas Flash Programmer, or by self-programming (by the software running on the device).
To program only the data flash with Renesas Flash Programmer, the file used to program the device would require to hold only data for the data flash address range. A. srec,. hex, or. bin file can be used with RFP to give the data to be programmed into the flash.
Regards
Ashish
See less