How to use MD pin in Flash time or Debug time or how to program Renesas RA2L1 MCU by using Renesas flash programmer ?
Share
Sign Up to our social questions and Answers Engine to ask questions, answer people's questions, and connect with other people.
Login to our social questions & Answers Engine to ask questions answer people's questions & connect with other people.
Volt.Tech
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Please briefly explain why you feel this user should be reported.
How to use MD pin in Flash time or Debug time or how to program Renesas RA2L1 MCU by using Renesas flash programmer ?
Hi mr. Raja You have to make MD pin active low while SCI boot (flashing with UART ) & if you want to debug the make it high with 10 K pullup & isolate pull down resistor
Hi mr. Raja
You have to make MD pin active low while SCI boot (flashing with UART )
& if you want to debug the make it high with 10 K pullup & isolate pull down resistor
See less