Home/Questions/Q 1286
Next
In Process
vikas Nagpal
  • 0
Asked: 2022-07-05T18:53:04+05:30 In:

Programming in Renesas RA6M1 using E2 emulator lite

  • 0

While trying to program the Renesas RA6M1 controller using the JTAG SMD connection, I am using the Renesas Ra6M1 eval board and facing the following error

Is this a problem with the JTAG GNDDETECT?

I have cut the traces E32-E38 on the board.

Please note that I am using the E2 lite debugger to program the board. I have soldered the JTAG GND Detect Traces.

e2 emulator litemicrocontrollerrenesasRenesas Microcontrollerrenesas ra6m1
Share

    Related Questions

    1 Answer

    1. Pls check for boot jumper refer below link to download E2 lite manual for connection reference   https://www.renesas.com/in/en/document/mat/e2-emulator-e2-emulator-lite-additional-document-users-manual-notes-connection-ra-devices

      Pls check for boot jumper

      refer below link to download E2 lite manual for connection reference

       

      https://www.renesas.com/in/en/document/mat/e2-emulator-e2-emulator-lite-additional-document-users-manual-notes-connection-ra-devices

      See less
      • 0

    Leave an answer

    You must login to add an answer.

    Need An Account,