I am getting error to update firmware when trying to burn program in XDPL8210 IC using .dpvision tool.
Please advise some solution ?
Share
Sign Up to our social questions and Answers Engine to ask questions, answer people's questions, and connect with other people.
Login to our social questions & Answers Engine to ask questions answer people's questions & connect with other people.
Volt.Tech
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Please briefly explain why you feel this user should be reported.
As the XDPL8210 chip on the 35 W reference design PCB has a first full set of parameters in its One-Time Programmable (OTP) memory space, only changed parameters are written in the OTP memory. 1 Load configuration file (see example in Figure 7). 2 Modify the parameter value needed, then press [File]Read more
As the XDPL8210 chip on the 35 W reference design PCB has a first full set of parameters in its One-Time
Programmable (OTP) memory space, only changed parameters are written in the OTP memory.
1 Load configuration file (see example in Figure 7).
2 Modify the parameter value needed, then press [File] >> [Save] or [File] >> [Save as] to save
the configuration file. Otherwise, proceed to step 3.
3
(optional)
Disconnect or turn off AC input voltage and check the hardware connection for configuration,
see Figure 2 and Figure 3.
4 Press to supply power and establish connection to the target XDPL8210. After this,
XDPL8210 will enter configuration mode and the device status should change to .
5
Press to burn the configuration into target XDPL8210.
After this step, a window pops up, like one of these below.
Note: If the parameter configuration is equivalent to to the pre-existing parameters, the
See lessXDPL8210 will not burn them in the OTP memory.
6 Press “Proceed” or “Yes” to burn the configuration. After this, a window pops up indicating
success.
7 Press “OK” on the pop-up window then disconnect the programming cable from the board
connector and test the application, if needed.