Hello, I need to use both UART and SPI interface, FX3’s SPI interface and UART interface are shared, now my SPI is connected to FLASH, I need to power on through SPI FLASH, so I can not use its UART function, but FX3 has” 16- bit data bus UART SPI I2S” mode. In this mode, UART is mapped to GPIO46-49. Can I use the following settings to enable me to use both UART and SPI FLASH BOOT?
io_cfg.isDQ32Bit = CyFalse;
io_cfg.s0Mode = CY_U3P_SPORT_INACTIVE;
io_cfg.s1Mode = CY_U3P_SPORT_INACTIVE;
io_cfg.useUart = CyTrue;
io_cfg.useI2C = CyFalse;
io_cfg.useI2S = CyFalse;
io_cfg.useSpi = CyTure;
io_cfg.lppMode = CY_U3P_IO_MATRIX_LPP_DEFAULT;
/* No GPIOs are enabled. */
io_cfg.gpioSimpleEn[0] = 0;
io_cfg.gpioSimpleEn[1] = 0x08000000;
io_cfg.gpioComplexEn[0] = 0;
io_cfg.gpioComplexEn[1] = 0;
And, can I still use the virtual COM port function of the UART in this mode?