Hi,
I need help with the PDO2 output in STUSB4500. In spite of setting the PDO Number as 3 and configuring the PDO2 voltage and current values using the STSW- STUSB002 GUI, I can not get any voltage output at PDO2. The status LED is also not glowing. But PDO1 and PDO3 are working OK.
However, I get the PDO2 voltage output, If I change the PDO Number to 2 with the same voltage and current configurations as over. The status LED also glows. So, this isn’t the problem of Source Matching. I’m unable to find out the reason why this is passing and how can I make all the 3 PDOs work easily.
Is there anything that I’m missing in making all the 3 PDOs work together?
Thank You
Hello I assume that you're using our STEVAL_ISC005V1 board and what you call 'PDO1' is Vsnk from the schematic. However, Vsnk lights are on for all PDOs selections. Whereas PDO2 is ON if PDO2 is selected and PDO3 if PDO3 is selected. Our algorithm always tries to select the highest voltage. If the cRead more
Hello
I assume that you’re using our STEVAL_ISC005V1 board and what you call ‘PDO1’ is Vsnk from the schematic.
However, Vsnk lights are on for all PDOs selections. Whereas PDO2 is ON if PDO2 is selected and PDO3 if PDO3 is selected.
Our algorithm always tries to select the highest voltage. If the charger is so that PDO3 can be selected, then PDO3 Vsink will light on,
However, also PDO2 Vsnk will light ON. If the charger is smaller.
Best regards
Ashish Gawade
See less