Sign Up to our social questions and Answers Engine to ask questions, answer people's questions, and connect with other people.
Login to our social questions & Answers Engine to ask questions answer people's questions & connect with other people.
Volt.Tech
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Please briefly explain why you feel this user should be reported.
Hi Team,
We’re using the MCU Boot for the RA4M2 Evaluation board from the suggested Photo –EK_RA4M2_MCUBoot_BL.
The project gets stuck at the stage- Verify the boot image and get its position.
Below is the error observed while executing the design.
Below is the storage allocation for different sectors-
Kindly, suggest a resolution for the same.
Thanks and Regards,
Ella Smith
Hello, When the RA4M2 MCU boot process stops at the "Verify boot image" stage, it indicates that the microcontroller is unable to successfully verify the integrity of the boot image being loaded. Here are a few possible reasons and troubleshooting steps to resolve the issue: Incorrect boot image CorRead more
Hello,
When the RA4M2 MCU boot process stops at the “Verify boot image” stage, it indicates that the microcontroller is unable to successfully verify the integrity of the boot image being loaded.
Here are a few possible reasons and troubleshooting steps to resolve the issue:
It’s important to note that the exact steps and solutions may vary depending on the specific development environment, tools, and firmware used. Therefore, consulting the relevant documentation and seeking manufacturer support is highly recommended to resolve the “Verify boot image” issue with the RA4M2 MCU.
Thank You
Ashish
See less