Sign Up to our social questions and Answers Engine to ask questions, answer people's questions, and connect with other people.
Login to our social questions & Answers Engine to ask questions answer people's questions & connect with other people.
Volt.Tech
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Please briefly explain why you feel this user should be reported.
Infineon XDPL IC
.
.
See lessInfineon XDPL IC
Hi Manoj, "Please go through the link given below for Reference design – Fine tuning guide (pg no.: 29 – 33) & Debugging Guide (pg no.: 34 – 38). You have to operate the driver in debug mode and check the fault error code as per the steps given in Reference design. Then after knowing the error cRead more
Hi Manoj,
“Please go through the link given below for Reference design – Fine tuning guide (pg no.: 29 – 33) & Debugging Guide (pg no.: 34 – 38).
See lessYou have to operate the driver in debug mode and check the fault error code as per the steps given in Reference design.
Then after knowing the error code & fault which is triggering driver ON/OFF/ON, you can correct the design accordingly by following the design guide of 40W Reference design. Please find the link below.
https://www.infineon.com/dgdl/Infineon-ApplicationNote_ReferenceBoard_REF-XDPL8105-CDM10V-ApplicationNotes-v02_00-EN.pdf?fileId=5546d462584d1d4a0158962cb4ed4315“
Connect UART with .dp vision Gen 2
Hi Manoj. Connection needs to be done b/w .dp Vision Gen2 Pin 2,3 &4. Where • Pin 4 is VCC • Pin 2 is GND • Pin 3 is UART Connect accordingly.
Hi Manoj.
Connection needs to be done b/w .dp Vision Gen2 Pin 2,3 &4. Where
See less• Pin 4 is VCC
• Pin 2 is GND
• Pin 3 is UART
Connect accordingly.