Sign Up to our social questions and Answers Engine to ask questions, answer people's questions, and connect with other people.
Login to our social questions & Answers Engine to ask questions answer people's questions & connect with other people.
Volt.Tech
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Please briefly explain why you feel this user should be reported.
ESP32 Series Audio Development Board
The NS4150 PA used by the ESP32 development board has a maximum power of 3 W, as stated in its datasheet.
The NS4150 PA used by the ESP32 development board has a maximum power of 3 W, as stated in its datasheet.
See lessled’s are not glow equally during dc operation in emergency 4ft batten
hi as per my advise you can use 2 option Since there are 112 leds used in parallel and there is a very low voltage and high current, you should change your series and parallel configuration. You can do this by changing the track width on your PCB board and by installing a CC IC, which will boRead more
hi as per my advise you can use 2 option
You can do this by changing the track width on your PCB board and by installing a CC IC, which will boost the current and give each led an equal amount of current then your issue will be resolved.
Thanks
LED Chip 5050
Hi , Please check the junction temperature , may be if temperature goes high then same issue can be happen . Thanks Zazho
Hi ,
Please check the junction temperature , may be if temperature goes high then same issue can be happen .
Thanks
Zazho
See less