Sign Up to our social questions and Answers Engine to ask questions, answer people's questions, and connect with other people.
Login to our social questions & Answers Engine to ask questions answer people's questions & connect with other people.
Volt.Tech
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Please briefly explain why you feel this user should be reported.
How to get PWM frequency support for devices?
Hello, This series of products are designed for the one-time switch, so it is used for low frequency, if PWM is applied, we would recommend using lower than 300Hz, or for parts even <100Hz, you may relate to the ton/toff time of the part for details. Thank You
Hello,
This series of products are designed for the one-time switch, so it is used for low frequency, if PWM is applied, we would recommend using lower than 300Hz, or for parts even <100Hz, you may relate to the ton/toff time of the part for details.
Thank You
See lessHow to Use of special IOs in ESP32-S3?
Hello, Yes. Be apprehensive that typically there will be some launch chatter on TxD0- if you are applying this pin for I2C and the different column stays idle, this is doubtful to make an issue, however, (similarly note that depending on the module/board, TxD0 may have a built-in 500-ohm series resiRead more
Hello,
Yes. Be apprehensive that typically there will be some launch chatter on TxD0– if you are applying this pin for I2C and the different column stays idle, this is doubtful to make an issue, however, (similarly note that depending on the module/board, TxD0 may have a built-in 500-ohm series resistor. It likely will not interfere too important with I2C, but if you are having issues streaming I2C at a high bitrate, it may be because the resistor limits the slew rate.)
Thank You
See less