In the RA mcu series by Renesas, what is the procedure for doing USB and SCI Boot mode
Sign Up to our social questions and Answers Engine to ask questions, answer people's questions, and connect with other people.
Login to our social questions & Answers Engine to ask questions answer people's questions & connect with other people.
Volt.Tech
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Please briefly explain why you feel this user should be reported.
In the RA mcu series by Renesas, what is the procedure for doing USB and SCI Boot mode
For USB boot mode: Target board_EK-RA2A1
Step1: USB FS is used for this mode, Connect Device USB (J9) on EK-RA2A1 board.
Step2: Power the board using Debug USB or external Power.
Step3: Press the RESET button(S2), once done you can find the comport detected, which can be verified in the device manager list.
Step4: Open the RFP tool and create project as below, In Tool select COM Port, COM 12 detected automatically(verify in ports RA USB Boot (CDC) (Com 12) ).
Step5: Once Project is successfully created, Browse the .SREC file in debug folder of your project E:\MOHAN ..PATH \RA2L1\Workspace\EK_RA2A1_LED\Debug\EK_RA2A1_LED.srec
STEP6: Again press RESET button S2, and give Start, Once Completed you will find a message” Operation completed”
STEP7: Do a power cycle, so that the application will be running.
Refer link: